As noted in the last issue, I had to go to Seward to be a presenter, along with Kaye Dethridge and Irene Shuler, at the Alaska HistoricalSociety's annual meeting. The high point of the trip was a late breakfast with Kaye and Irene, and also Tom Dalrymple.

During our meal, Tom made the comment that he had had an extraction the previous day, and slid a small plastic box across the table to me. It wasa cute little box, with a tooth fairy on the top. Inside was a gold crown from one of Tom's wisdom teeth. Some might say that this was not anappropriate meal time topic, but it was only the crown, no tooth. As he slid it across the table, he said "Make something for me."

Tom is an assistant professor of accounting at Kenai Peninsula College. After spending three days with him at the coin show at the Kenai PeninsulaFair in Ninilchik in August, I came to appreciate his sense of humor. I am sure he found this greatly entertaining.

Driving to Anchorage to catch the flight back to Fairbanks, I was thinking about the tooth. About the only thing that Tom could even think I couldmake was a token. So, what kind of token? Let's see. It was a wisdom tooth, so "WISDOM" something. "MAY YOU HAVE WISDOM." The other side would simplybe TOM'S TOOTH.

I figured this would be easy. It was not. When melted into a button, because of the alloy of dental gold, the tooth had a very dark top surface.The lighter components go to the surface and oxidize. Various means were tried to remove this discoloration. Finally an acid bath was successful.

Once the dark film was removed, I could start forming the button into a planchet using the screw press. After one or two presses, it must beannealed again to prevent cracks from forming around the edge.

And the dark film was back, which means back into the acid. After several rounds of flattening, annealing and acid bathing, the button was largeenough to cover the dies.

This done, I set up the dies in the screw press and gave the swing arm a good throw. I looked at the results - very faint. It was so faint, I hada hard time reseating the token in the dies. I pressed it 4, 5, 6 more times, and it was still faint.

It was once again back to several rounds of annealing, acid bathing and pressing. This procedure was followed at least four times before I gaveup. It was as good as it was going to get. Besides, the dies were now bent out of shape. And so was I! This had taken four hours.

And the lesson I learned was....don't play with dental gold. It is too hard.

I made silver tokens for Tom to go along with the gold (after all, he did pay for breakfast), and these pressed like butter!